| Kart Set-Up Sheets Need a little set-up help. Start with this for your XE28 kart. This is the recommended suggested starting setup for an Arrow XE28 Chassis. Kart Model: Arrow XE28 Chassis Class: 40mm Axle Event: Standard Set-up Date: 2009 AXLE SIZE: 40mm TYRES: MG Red/Dunlop SL6 Tyre FRONT CRASH BAR: Loose REAR CRASH BAR: Tight REAR RIDE HEIGHT: High (axle down in it's lowest position) REAR TRACK: 1380mm REAR AXLE TYPE: M1 - 40mm (1050mm) FRONT RIDE HEIGHT: Central FRONT TOE: 2mm OUT Overall FRONT TRACK: 20mm spacers on inside each front wheel FRONT CASTER: Minimum FRONT CAMBER: 2mm POSITIVE Overall FRONT CLAMP: Removed SIDE POD BARS: Front bolts loose, Rear bolts tight SEAT STAYS: Tight (One each side) SIDE TORSION BAR: REAR TORSION BAR: REAR HUB LENGTH: 80mm ACKERMAN: Maximum (inner hole on stub-axle arm)
Kart Model: Arrow XE28 Chassis Class: National Event: Standard Set-up Date: 2009 AXLE SIZE: 30mm TYRES: Dunlop SL1 Tyre FRONT CRASH BAR: Tight REAR CRASH BAR: Tight REAR RIDE HEIGHT: High (axle down in it's lowest position) REAR TRACK: 1300mm REAR AXLE TYPE: AX30TWL - 30mm (1050mm) FRONT RIDE HEIGHT: Central FRONT TOE: 2mm OUT Overall FRONT TRACK: 10mm spacers on inside each front wheel FRONT CASTER: Minimum FRONT CAMBER: No Camber FRONT CLAMP: Removed SIDE POD BARS: Front bolts loose, Rear bolts loose SEAT STAYS: None SIDE TORSION BAR: REAR TORSION BAR: REAR HUB LENGTH: 80mm ACKERMAN: Maximum (inner hole on stub-axle arm)
| 
